P7 Complete External Battery Kit


Home Products History Buy Contact


With regret, Turboferret Industries has ceased production due to personal reasons. Once stocks have run out, trading will stop completely. Please note stock levels for individual parts on the buy page when ordering. These will be updated daily, but may not be totally up to date, so adjustments may be required subsequent to your purchase. Many thanks for all of the support over the past year.

Holders are no longer available soldered. All parts will be delivered assembled, and instructions for wiring to give the appropriate configurations will be available. Kits will be available in component form only, not fully assembled.



Complete kit to run an external pouch with a P7 torch, with only minor torch modification required

Kit contains a holder (quad or twin), dummy cell, cable (without or without plugs), cable grommet and battery pouch.

Available in a variety of configurations depending on requirements -

Quad Twin Budget 1 quad holder, 2 x dummy cells, 2 x cables, grommets + pouch £33

Quad Budget 1 quad holder, dummy cell, cable, grommet + pouch £25

Twin Budget 1 twin holder, dummy cell, cable, grommet + pouch £23.50

Soldering is required, parts not assembled - the purchaser needs to cut a slot in the body for the cable to emerge, but this means that the torch can be easily swapped back to nomal operation using a single internal 18650 cell.

P7 torch modification

Disclaimer
The 5 mode MTE P7 light has a rather weak driver, which may not be able to handle the additional current supplied by the extra li-ion cells. Should you want to use an external pack with a 5 mode light, this driver should be a suitable replacement. 2 mode P7's are directly driven for high power, with a resistor for low power, so have no vulnerable circuitry. Turboferret Industries accepts no resposibility for damage to customers equipment.

This holder is designed to be used only with protected cells as there is no additional protection circuitry built in.

Quality
Please be aware that these are not mass-produced injection moulded items, they are hand cast in small numbers by hand using silicon moulds. Although the quality of the holders is good, please expect the odd small air bubble due to the moulding process. If this puts you off, you should look elsewhere.

Lead Time
Turboferret is now based in Italy for 3 weeks a month, but returning to the UK once a month. Production continues, but despatch will be on a monthly basis from the UK, lead time will therefore be typically 3 weeks, but should never be any more than 1 month. Contact me to find out when I will next be shipping orders.